Haltech Elite 2500 GM GEN III LS1 (DBW Ready) Term Harn Only - EV1 (HT-141362)

Haltech Elite 2500 GM GEN III LS1 (DBW Ready) Term Harn Only - EV1 (HT-141362)If you are using a factory harness and are after an easy ECU upgrade, take a look at Haltech Plug'n'Play Adaptor Kits. These adaptors plug directly into your Haltech ECU and have a set of factory connectors on the other side which plug straight into the factory harness. Simple Haltech Plug'n'Play product that allows you to be up and running in just a few hours. Quick start guide will walk you through installation of the Haltech Plug'n'Play adaptor

• Simple Haltech Plug'n'Play product that allows you to be up and running in just a few hours.
• Quick start guide will walk you through installation of the Haltech Plug'n'Play adaptor into your vehicle.
• Guide is accompanied by the full ECU manual and Software located on the CD or USB key provided with the ECU to refer to while completing your installation and configuration.

Features:

• Harness when installed in conjunction with a Haltech Elite ECU opens the door to virtually limitless performance modification and tuning of your vehicle.
• Programmable systems allow you to extract all the performance from your engine by delivering precisely the required amount of fuel and ignition timing that your engine requires for maximum output under all operating conditions. 

Notes:

• Suits: Retrofit of a GEN IV LS2/3 DBW throttlebody. Common US style Delco/Bosch GM alternator connector. Pre-wired to connect directly to OEM 7 Pin Coil Harness Connector. WBC1/2 CAN O2 Wideband Controller ready (Controller and sensor(s) not included) Manual transmission only.

• Includes: Engine harness with fuse block and firewall grommet.
• Notes: Please confirm your alternator connector (See the product quick start guide) and order an alternator adaptor if required. (HT-040090 or HT-040091) Ignition coils and harnesses are NOT included, Please order 8 x HT-020102 and/or HT-045657 if required.